If there is output levels like than then its fine. I would actually wire that onto the ext audio pins of the riser and let them get mixed into the audio output from the CD32 RCA jacks.arkadiusz.makarenko wrote: ↑Sat Feb 13, 2021 10:07 amDon't know, I just looked at Raspberry Pi HIFI solutions.
Output is Direct Line Level 2.1-VRMS. Whatever it means.
Anyway I will try to understand it a little bit more.
Maybe there is enough data bandwidth to send decoded data back to Amiga and play it from there?
TF CD32 Riser Revision 3 Design discussion
Moderators: terriblefire, Terriblefire Moderator
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: TF CD32 Riser Revision 3 Design discussion
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- arkadiusz.makarenko
- Moderator Team
- Posts: 1208
- Joined: Wed Jun 19, 2019 7:36 am
- Location: Edinburgh
Re: TF CD32 Riser Revision 3 Design discussion
I have ordered dev board with this chip, and I will play with it if it is worth the effort.terriblefire wrote: ↑Sun Feb 14, 2021 9:43 amIf there is output levels like than then its fine. I would actually wire that onto the ext audio pins of the riser and let them get mixed into the audio output from the CD32 RCA jacks.arkadiusz.makarenko wrote: ↑Sat Feb 13, 2021 10:07 am
Don't know, I just looked at Raspberry Pi HIFI solutions.
Output is Direct Line Level 2.1-VRMS. Whatever it means.
Anyway I will try to understand it a little bit more.
Maybe there is enough data bandwidth to send decoded data back to Amiga and play it from there?
Do not trust people. They are capable of greatness.
~ Stanislaw Lem
~ Stanislaw Lem
- arkadiusz.makarenko
- Moderator Team
- Posts: 1208
- Joined: Wed Jun 19, 2019 7:36 am
- Location: Edinburgh
Re: TF CD32 Riser Revision 3 Design discussion
I am starting new job tomorrow, so I packed CD32 for a while, as I got too distracted recently. I will put it on my bench again, when I settle in new post. Meanwhile I have set up my A1200 .
Do not trust people. They are capable of greatness.
~ Stanislaw Lem
~ Stanislaw Lem
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: TF CD32 Riser Revision 3 Design discussion
Oh i'll have to supply you something for thatarkadiusz.makarenko wrote: ↑Mon Feb 15, 2021 6:17 pm I am starting new job tomorrow, so I packed CD32 for a while, as I got too distracted recently. I will put it on my bench again, when I settle in new post. Meanwhile I have set up my A1200 .
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."