Would appreciate some advice as the best way to go about this. The following RT1430B6 'type F' BGA resistor network seems impossible to find and I'm wondering if it can be re-created with some ingenuity.
If I got 2x 10pin resistor SIL arrays, soldered them to the top & bottom corresponding line of pads ... then ran a wire down the centre pads which are common/gnd, then linked the common pin of the two resistor arrays to this gnd line - would it be ok? Sorry! hard to explain!
Code: Select all
--------------------
| | | | | | | | |
* * * * * * * * *
*-*-*-*-*-*-*-*-*
* * * * * * * * *
| | | | | | | | |
--------------------