My STe came with no reset button button - I couldn't find a 3D one to print so knocked this up in openscad - should tightly snap fit *IF* printing with highest quality/smallest/finest layers you can and your extrusion amount (Material > Flow) is just right (calculated mine to 95.0 in Cura for my Ender Pro 3) as the margins are very fine.
Reset button on mine is 2.8mm square - so if yours isn't this won't help!
If your machine isn't calibrated or if it's too tight I would suggest knocking it back the Flow 1 at a time and reprinting (obv. it's tiny and only takes a few mins to print so not a major hassle) as this will fractionally increase the internal diameter of the snap bits
- [also it sticks out about 1 mm longer than the original]
Ste reset button button
Ste reset button button
- Attachments
-
- atati_st_reset_button3.stl
- (152.23 KiB) Downloaded 93 times
Re: Ste reset button button
https://www.exxosforum.co.uk/atari/ All my hardware guides - mods - games - STOS
https://www.exxosforum.co.uk/atari/store2/ - All my hardware mods for sale - Please help support by making a purchase.
viewtopic.php?f=17&t=1585 Have you done the Mandatory Fixes ?
Just because a lot of people agree on something, doesn't make it a fact. ~exxos ~
People should find solutions to problems, not find problems with solutions.
https://www.exxosforum.co.uk/atari/store2/ - All my hardware mods for sale - Please help support by making a purchase.
viewtopic.php?f=17&t=1585 Have you done the Mandatory Fixes ?
Just because a lot of people agree on something, doesn't make it a fact. ~exxos ~
People should find solutions to problems, not find problems with solutions.