Getting software to work on 68LC060

News & updates for the upcoming 68060 accelerator

Moderators: terriblefire, Terriblefire Moderator

Crumb
Posts: 6
Joined: Mon Sep 16, 2019 3:56 pm

Re: Getting software to work on 68LC060

Post by Crumb »

alenppc wrote: Wed Sep 02, 2020 9:12 pm
8 Bit Dreams wrote: Wed Sep 02, 2020 9:10 pm Alen, did You tried to install this Lib?
http://www.amibay.com/showthread.php?11 ... ary-update
Yes, totally pointless. It does not emulate an FPU, simply removes the FPU managment code so even Femu crashes. Avoid.
It should be possible to update femu to support 060. Perhaps Thor could integrate It after it's adapted
alenppc
Moderator Team
Moderator Team
Posts: 906
Joined: Thu Nov 08, 2018 12:59 pm

Re: Getting software to work on 68LC060

Post by alenppc »

Femu.040 works well enough, just use the regular 68060 libraries.

By the way, novacoder has kindly recompiled Zdoom for LC060 and even AmiQuake (but the latter runs like a slideshow, so it’s more of a ‘it-can-be-done’ type of thing.
terriblefire
Moderator Team
Moderator Team
Posts: 5368
Joined: Mon Aug 28, 2017 10:56 pm
Location: Glasgow, UK

Re: Getting software to work on 68LC060

Post by terriblefire »

alenppc wrote: Sun Sep 06, 2020 6:01 pm Femu.040 works well enough, just use the regular 68060 libraries.

By the way, novacoder has kindly recompiled Zdoom for LC060 and even AmiQuake (but the latter runs like a slideshow, so it’s more of a ‘it-can-be-done’ type of thing.
Yeah If it was patched with the PocketQuake patches it would shift.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
sugar
Posts: 77
Joined: Sat Apr 20, 2019 10:28 pm

Re: Getting software to work on 68LC060

Post by sugar »

I acquired a few LC cpus and tried them with my TF360. Two of them run happily but the other two just cause graphical glitches and no actual graphics.
Higgy
Posts: 400
Joined: Tue Apr 23, 2019 8:05 pm
Location: Somerset

Re: Getting software to work on 68LC060

Post by Higgy »

Did WhichAmiga report all the LC's being the same Rev etc?

I expect Mr Remark will be busy teaching his crew how to remove 2 horizontal lines: EC -> LC :)
sugar
Posts: 77
Joined: Sat Apr 20, 2019 10:28 pm

Re: Getting software to work on 68LC060

Post by sugar »

Higgy wrote: Thu Sep 10, 2020 9:18 pm Did WhichAmiga report all the LC's being the same Rev etc?

I expect Mr Remark will be busy teaching his crew how to remove 2 horizontal lines: EC -> LC :)
No I mean I just get some crap on screen so I don't get that far :-) The CPUs look identical and very much legitimate, the ones that work are identified as rev 4. I had some fake chinese rev6s but they only gave me a black screen so this is something different so curious about this.
Post Reply

Return to “TF360”