kodak80 H5 A3 builds

Share your building progress here!
Post Reply
User avatar
kodak80
Posts: 372
Joined: Sat Oct 21, 2017 1:14 am
Location: Brisbane,QLD Australia
Contact:
Contact kodak80

Re: kodak80 H5 A3 builds

Post by kodak80 »

exxos wrote: ↑Fri Jan 22, 2021 10:08 pm
kodak80 wrote: ↑Fri Jan 22, 2021 10:00 pm I have a question regarding SMD resistor network (RN) components. Does the orientation of SMD RN on the H5 boards matter?
Nope, they are just single resistors in a "pack of 4".
Okay, good to know. Thank you.
Atari Falcon 030 | Atari 1040 STE | Atari 1040 STFM | Atari 1040 STF | Kryoflux & Supercard Pro Flux boards
Creator of the Atari ST Review magazine archive: https://www.chillichai.com/atari-st-review
Top
User avatar
kodak80
Posts: 372
Joined: Sat Oct 21, 2017 1:14 am
Location: Brisbane,QLD Australia
Contact:
Contact kodak80

Re: kodak80 H5 A3 builds

Post by kodak80 »

kodak80 wrote: ↑Fri Jan 22, 2021 10:00 pm I have put aside the A3 board for now and started to build my three B1 boards up.
Okay, 3 years later and I have finally got back to looking at why this H5 A3 board was not booting. Turns out the fix on the reset IC22 was soldered to the GND pin 1 and not pin 2 :oops:

Image

The board is now booting and shows a desktop so another one comes to life. :)

I guess this means that my other three A3 boards should now be built up.
Atari Falcon 030 | Atari 1040 STE | Atari 1040 STFM | Atari 1040 STF | Kryoflux & Supercard Pro Flux boards
Creator of the Atari ST Review magazine archive: https://www.chillichai.com/atari-st-review
Top
Post Reply

Return to “H5 A3 USER BUILDS”